![]() ![]() Well, guess what my Samsung open/close sensor I have on the back slider shows that the last time it was closed was at 4:00 PM. Last night we got home around 8pm to a mess, the golden child swore that he had just let the dog out “20 minutes ago” and it’s not his fault. The problem is when my son is home alone with him, he’s in his room usually with headphones or music and although he swears that he lets the dog out often, we almost always come home to pee on the floor. This would need to be something that attaches to his collar with a sensor placed at the door and triggers when he’s within 1-2 feet of it and sends a real time alert.Ī little backstory: it’s never really an issue when the adults are home because we’re either in the living room/kitchen or the dog is with us in the bedroom. I was looking at some pet fencing solutions to keep the cats in but for now I just want an alert when the dog is at the door and wants to go outside so one of us can go let him out. We have 2 cats that are not allowed outside because we live very close to coyotes so a pet door is not an option. We have a small, older dog that doesn’t make much noise but knows to go up to the back slider when he wants to go out. I need a dog collar FOB with a sensor that triggers within a foot or two. Most products I’ve seen do the opposite, ignoring small pets. ![]() I’m trying to find a very close proximity sensor, like within a foot or so that can send an alert when triggered. In order to re-enter normal operational model, simply remove and replace power to the device.I have a bit of a unique situation that I’m trying to solve. Select the DFU button to reboot the beacon into Direct Firmware Update mode.Ĭontact Radius Networks support for information on the procedure for firmware update or replacement. In order to re-enter configurable mode for a RadBeacon X2, remove the front cover and switch the beacon power switch to OFF and back to ON.Ī beacon set in configurable mode will be configurable for up to 30 minutes or until you lock the device again. In order to re-enter configurable mode for a RadBeacon Tag, remove the front cover and press the configuration push button switch near the coin cell battery. In order to re-enter configurable mode for a RadBeacon USB, remove and restore power to the device. The Lock feature is a security precaution to limit the possibility of third party manipulation of your beacons once they have been installed and configured. Select the Lock button to submit a valid PIN to prevent connections from remote Bluetooth 4.0 devices to the beacon configuration service. Submit a valid PIN to reset the settings for your beacon to factory defaults. Select the Reset button to reset the device to the original factory settings. Select the Update PIN button to submit a new and existing PIN to update the PIN for your beacon. Advertised Organizational Identifier Ĭhange any of the modifiable settings and select the Apply button to submit a valid PIN to update the settings for this beacon. Select any RadBeacon in the table to view it's detailed settings. Each beacon discovered is displayed with the following summary details Scan for nearby configurable RadBeacons by pressing the Start Scanning button. Once discovered, you can display each beacon's operating settings and make modifications to those settings. With the RadBeacon app you can scan for nearby configurable Radius Networks beacons. The RadBeacon app from Radius Networks requires a Macintosh computer running OS X 10.9 or higher and equipped with Bluetooth 4.0 capabilities. The RadBeacon™ app is the configuration utility for RadBeacon proximity beacons from Radius Networks that support Apple's iBeacon™ proximity services as well as other emerging proximity services. ![]()
0 Comments
Leave a Reply. |